Vertical Oscillation Model of Sowing Machine Combined with Fertilization for Soybean

Received: 10-08-2020

Accepted: 23-02-2021

DOI:

Views

0

Downloads

0

Section:

KỸ THUẬT VÀ CÔNG NGHỆ

How to Cite:

Thong, N., Lu, L., Thiet, N., & Nguyen, N. (2024). Vertical Oscillation Model of Sowing Machine Combined with Fertilization for Soybean. Vietnam Journal of Agricultural Sciences, 19(5), 652–661. http://testtapchi.vnua.edu.vn/index.php/vjasvn/article/view/824

Vertical Oscillation Model of Sowing Machine Combined with Fertilization for Soybean

Nguyen Chung Thong (*) 1 , Le Minh Lu 1 , Nguyen Xuan Thiet 1 , Nguyen Thi Hanh Nguyen 1

  • 1 Khoa Cơ - Điện, Học viện Nông nghiệp Việt Nam
  • Keywords

    Vertical oscillation, conjugate machine, sowing and fertilization machine for soybean

    Abstract


    This study presents the result of building the vertical oscillation model of the conjugate machine (sowing machine combined with fertilization for soybean (G4B2 machine) and tractor). The fluctuations of special points on the conjugate machine are described graphically through numerical methods by Matlab software when the parameters of the stimulus function change, in two cases: the continuous stimulating function and the single stimulating function cosine form. The tractor has a four-link hinge knuckle at the back, when working in the free state, the G4B2 machine oscillation affected by tractor oscillation is very small. The point near the wheel of the G4B2 machine has a smaller amplitude of oscillation than the remote point.It is necessary to decrease the feeding speed when combining the machine through the rough ground with large amplitude (h0 > 0.15m) and small steps (S0 < 1.0m).

    References

    Đặng Thế Huy (1995). Một số vấn đề về cơ học giải tích và cơ học máy. Nhà xuất bản Nông nghiệpHà Nội.

    Đỗ Sanh (1992). Giáo trình Cơ học (Tập 2) - Động lực học. Nhà xuất bản Giáo dục, Hà Nội.

    Flaugh A.B. (2011). Studies on Power Hop Using a onlinear Model of an Agricultural Tractor. Degree of Master of Science. University of Nebraska, US.

    Lê Minh Lư (2002). Nghiên cứu dao động của máy kéo bánh hơi có tính đến đặc trưng phi tuyến của các phần tử đàn hồi. Luận án Tiến sỹ. Trường Đại học Nông nghiệp I, Hà Nội.

    Nguyễn Chung Thông, Lê Minh Lư & Nguyễn Xuân Thiết (2018). Một số kết quả nghiên cứu về máy gieo hạt đậu tương kết hợp với bón phân theo hướng cơ giới hóa đồng bộ. Kỷ yếu Hội nghị Khoa học và Công nghệ toàn quốc về Cơ khí lần thứ V - VCME2018. Nhà xuất bản Khoa học và Kỹ thuật. tr. 1026-1035.